PanelView Plus 7 – Reset to Factory Defaults

In today’s article I’ll walk you through resetting your PanelView Plus 7 to Factory Defaults:

Step 1) Plug a USB Keyboard into your PanelView Plus 7:

Step 2) Cycle Power to your PanelView Plus 7 while holding down the F1 Key:

Step 3) When the Maintenance Menu comes up, press the down arrow key once to select “Special BOOT Option – None”

Step 4) Now press the right key until you see “Special BOOT Option – Factory Defaults”

Step 5) Now press the up arrow key to select “Reboot With Selected Options” and press enter:

Step 6) At this point your PanelView Plus 7 will reboot and reload the default firmware it came with, which in this case was 7.0:

Step 7) This also reset the units desktop access password back to the default password of “password”

To watch a video demonstration of the above, check out Episode 38 of The Automation Minute Season 4 below:

If you found this article helpful, please share it with your colleagues on LinkedIn, Facebook, Twitter or Goggle Plus!

And if you know anyone who would benefit from PanelView Plus training, please let them know about my affordable courses over at TheAutomation School.

You can also share your own thoughts and opinions on this subject by clicking on the “post a comment or question” link below.

Until next time, Peace ✌️ 

If you enjoy this episode please give it a Like, and consider Sharing as this is the best way for us to find new guests to come on the show.

Shawn M Tierney
Technology Enthusiast & Content Creator

Eliminate commercials and gain access to my weekly full length hands-on, news, and Q&A sessions by becoming a member at The Automation Blog or on YouTube. You'll also find all of my affordable PLC, HMI, and SCADA courses at TheAutomationSchool.com.

• Author
• Recent Posts

Shawn Tierney

I'm a lifelong Technology Enthusiast who started programing in the early 80's on the new Apple II and VIC-20 personal computers. After earning a degree in Electronics, I worked as a Certified Automation Specialist for 25 years before leaving to focus on teaching at The Automation School, as well as publishing industry news and product how-to’s at The Automation Blog.

Latest posts by Shawn Tierney (see all)

• TAP228 Aftershow: Can Ai Really Explain, Write and Edit PLC Code? (PAS01) - November 22, 2024
• Automation Q & A for November 22, 2024 (QW023) - November 22, 2024
• SLC-500 Migrations Compared: SoftPLC vs Studio 5000 (S2E10) - November 21, 2024