This Week On The Automation Minute

The Automation School – PLC Basics – Article Banner

This week on The Automation Minute

Last Friday I discussed what I think is the best PLC to learn on:

This Thursday I released a three part series on using the PanelView Plus Serial DH-485 driver:

Note: These videos were going to be part of one of my training courses, however after recording the videos I found that all the equipment on the table wrecked havoc with my wireless mic, and the only clean audio I had was from a backup mic that is closer to phone quality than studio quality. With that in mind, I decided to release them free on YouTube as I think they still contain a lot of good information. So this week I recorded new bumpers for them and released them as part of The Automation Minute series:

I hope you found this week’s videos helpful.

If you have any suggestions for future videos I’d love to hear them! Let me know by using the “Leave a reply” form at the bottom of this page.

And to watch our videos the day they’re released, visit TheAutomationMinute.com or subscribe to us on YouTube.

You can also purchase and download any of our previous episodes for just 99¢ each, our buy the entire series for $14.99 HERE.

Sincerely,

Shawn Tierney
Automation Blogger and Trainer

Insights In Automation

Download my automation videos starting at 99¢ HERE

The Automation School – PLC Basics – Article Banner

Check Also

RSLogix-MIcro-Starter-Splash-Fi

What’s new in RSLogix 500 and Micro v11

RSLogix 500 and RSLogix Micro version 11 is out, and in today’s article we’ll take …

How do I get a copy of a PanelView Plus application to edit?

This is a question I get asked quite a bit. And that’s probably because it’s …