In part 1 of this episode of The Automation Show, I unbox a Mitsubishi FX-5 PLC, then register, download, and install the programming software, GX Works 3:
For more information, check out the “Show Notes” located below the video.
The Automation Show, Episode 28A Show Notes:
Support our site and get early access to our shows and podcasts!
You can now support our site with a small monthly pledge and in turn receive instant rewards! To find out more visit https://Patreon.com/Automation.
You can also purchase the entire season of The Automation Show for a one time donation of $25 at https://vimeo.com/ondemand/theautomationshow.
Thanks in advanced for your support!
Vendors: Would you like your product featured on the Show and Blog? If you would, please contact me at: https://theautomationblog.com/contact
Sponsor and Advertise: Get your product or service in front of our 70K followers while also supporting independent automation journalism by sponsoring or advertising with us! Learn more in our Media Guide here, or contact us using this form or by calling our office at 413-749-4300.
- Get Data From MicroLogix via Modbus and NET-AIC? - August 8, 2022
- Can You Manually Reset A PLC Timer? - August 5, 2022
- Interviewing Dan Winchester, Controls Engineer (P113) - August 3, 2022