Allen-Bradley Ultra Servo Drive Software

The Automation School – PAC Basics – Article Banner Top

Article Updated November 2017:

What is Allen-Bradley Ultraware?

UltraWAREAllen-Bradley's Ultraware software allows you to setup and configure the follow A-B Servo Drives:

  • Ultra 1500
  • Ultra 3000
  • Ultra 5000

UltraWARE also includes troubleshooting and diagnostic tools to help with commissioning and integrating your Ulrta Servo Drives into your automation system.

Where to download free Allen-Bradley (A-B) Ultra Servo Drive Software:

Free Software Downloads From Rockwell Software Download ListingWhile the Allen-Bradley UltraWARE website has links to download the software, they either don't work or require logging in with a registered serial number. However, the Rockwell Software downloads webpage hosts the below link to download a copy of UltraWARE directly from Rockwell's website:


I hope the above information about where you can download UltraWARE software for free has been helpful.

If you have any comments or suggestions please don't hesitate to leave them with us. To do so, just fill in the “post a comment or question” link below.

Sincerely,

Shawn Tierney
Automation Blogger and Trainer
If you enjoyed my article, you may like my affordable courses at TheAutomationSchool.com


The Automation School – PAC Basics – Article Banner Top

Comments:

2 Old Comments:

  1. Hi,
    I have an Ultra5000 Allen-Bradley Drive since 2007 for a control of PM motor.
    It was stoped about 2 years, and now I installed ultraware version 1.8.
    I’m using an USB-RS232 serial cable, to link de ultraware software to the Drive.
    I think that the definitions of serial port is ok (38400bits; 8 bits, no parity, 1 stop bit, I also tried all flux control modes), but nothing…
    The ultraware doesn’t detect de Ultra5000 drive, and it’s status LED is OK.

    Do you know what it could be?

    Thanks in advance.
    Cheers from Portugal,
    LF

  2. Good morning LF,

    I’ve personally not used the 5000, so I’m not sure why you can’t connect? It does appear the CN3A port defaults to 38,400K for use with Ultraware. I would check to be sure you’re using a null modem cable, and if you are then check out this public tech note:

    https://rockwellautomation.custhelp.com/app/answers/detail/a_id/49520

    Hope this helps,

    Shawn Tierney

    If you enjoyed reading my article you may also like my affordable training courses at TheAutomationSchool.com

  3. mr shawn,ipersonally im downloading ultraware software,i would like to link into abb servo drive.i used rs 232 for the comm seriel port but cant communicate,,pls help or advice
    thanks and advance

  4. good day i have tried to download the ultraware software to no avail. could you kindly suggest a link as the current one you have posted shows error site.

Comments are closed.