MicroLogix 1400 – Use LCD to Enable DCOMM (M54)

In The Automation Minute: Episode 54, Shawn Tierney shows you how to use the MicroLogix 1400’s LCD to enable the serial port’s DCOMM mode.

Note: To find out how you can get a copy of Shawn’s low cost PLC training video visit http://www.TheAutomationSchool.com

Check out our Video Collection #1 here, which includes the first five seasons of our shows (over 280 episodes and 29 hours!) for just $30!

Until next time, Peace ✌️ 

Shawn M Tierney
Technology Enthusiast & Content Creator

Have a question? Join my community of automation professionals and take part in the discussion! You'll also find my PLC, HMI, and SCADA courses at TheAutomationSchool.com.

• Author
• Recent Posts

Shawn Tierney

Shawn is a lifelong Technology Enthusiast who as a pre-teen in the early 80's discovered his passion for programing on the newly released Apple II and VIC-20 computers. After earning a degree in Electronics, Shawn worked as a Certified Automation Specialist for 25 years before leaving to focus full time on teaching online PLC, HMI, and SCADA courses at The Automation School, as well as publishing industrial automation news, interviews, and how-to articles & videos at The Automation Blog.

Latest posts by Shawn Tierney (see all)

• Automation This Week for September 30, 2023 (W011) - September 30, 2023
• News for September 29, 2023 (N116) - September 29, 2023
• News for September 28, 2023 (N115) - September 28, 2023

(19 views)