In The Automation Minute: Episode 54, Shawn Tierney shows you how to use the MicroLogix 1400’s LCD to enable the serial port's DCOMM mode.
Note: To find out how you can get a copy of Shawn's low cost PLC training video visit http://www.TheAutomationSchool.com
If you've found this video helpful, checkout my training courses here.
You can now buy high definition digital downloads of The Automation Minute for just $1 each here.
Until next time, Peace ✌️
Shawn M Tierney
Technology Enthusiast & Content Creator
Have a question? Join my community of automation professionals and take part in the discussion! You'll also find my PLC, HMI, and SCADA courses at TheAutomationSchool.com.
Sponsor and Advertise: Get your product or service in front of our 75K followers while also supporting independent automation journalism by sponsoring or advertising with us! Learn more in our Media Guide here, or contact us using this form.
Shawn is a lifelong Technology Enthusiast who as a pre-teen in the early 80's discovered his passion for programing on the newly released Apple II and VIC-20 computers. After earning a degree in Electronics, Shawn worked as a Certified Automation Specialist for 25 years before leaving to focus full time on teaching online PLC, HMI, and SCADA courses at The Automation School, as well as publishing industrial automation news, interviews, and how-to articles & videos at The Automation Blog.
Latest posts by Shawn Tierney (see all)
- Automation Morning Show for March 31, 2023 - March 31, 2023
- Automation Morning Show for March 30, 2023 - March 30, 2023
- Prosoft EtherNet/IP to DH+ Gateway (P147) - March 29, 2023
[…] The Automation Minute, Episode 54: Use MicroLogix 1400’s LCD to Enable DCOMM […]
[…] The Automation Minute, Episode 54: Use MicroLogix 1400’s LCD to Enable DCOMM […]