Flex I/O

How to add ControlNet Flex I/O to ControlLogix (Article & Video, TAS 22)

In today's article (and video) I walk through how to add ControlNet Flex I/O to a ControlLogix system: NOTE: This article is not a comprehensive ControlNet tutorial, so if you're not already familiar with ControlNet you'll likely want to learn...

How to add Ethernet Flex I/O to ControlLogix (Article & Video, TAS 21)

In today's article (and video) I walk through how to add Ethernet Flex I/O to a ControlLogix System: Step 1) To start, open your RSLogix 5000 or Studio 5000 project and find your Ethernet communications module under I/O Configuration. Once...

Point I/O and Flex I/O Compared (Video, TAS 14)

In this week's episode of The Automation Show we compare and contrast Point I/O with Flex I/O: For more information, check out the "Show Notes" located below the video. [vimeo 366841556 w=750 h=420] The Automation Show, Episode 14 Show Notes: Previous article mentioned...

Point I/O vs Flex I/O

A reader recently asked what the difference was between Point I/O and Flex I/O, and in today's article I'll share my thoughts on the subject. Note: Those not familiar with Rockwell's I/O products may also want to consider 1756 I/O,...

Using The Sequencer Output Instruction in RSLogix/Studio 5000 (Video, TAS 7)

In this week's episode of The Automation Show, we walk through what it takes to use the Sequencer Output Instruction in RSLogix/Studio 5000: (starts at 3:00) For more information, check out the "Show Notes" located below the video. [vimeo 368573594 w=750...

Connect With Us!

698FollowersFollow
8,610SubscribersSubscribe