Flex I/O

Converting ControlNet I/O to EtherNet I/O

0
If you have had ControlLogix systems running in your facility for any amount of time, chances are they contain ControlNet communication modules for the communication between processor chassis and their controlled remote I/O chassis...

How to add ControlNet Flex I/O to ControlLogix (Article & Video, TAS 22)

0
In today's article (and video) I walk through how to add ControlNet Flex I/O to a ControlLogix system: NOTE: This article is not a comprehensive ControlNet tutorial, so if you're not already familiar with ControlNet...

How to add Ethernet Flex I/O to ControlLogix (Article & Video, TAS 21)

2
In today's article (and video) I walk through how to add Ethernet Flex I/O to a ControlLogix System: Step 1) To start, open your RSLogix 5000 or Studio 5000 project and find your Ethernet communications...

Point I/O and Flex I/O Compared (Video, TAS 14)

2
In this week's episode of The Automation Show we compare and contrast Point I/O with Flex I/O: For more information, check out the "Show Notes" located below the video. [vimeo 366841556 w=750 h=420] The Automation Show, Episode...

Point I/O vs Flex I/O

3
A reader recently asked what the difference was between Point I/O and Flex I/O, and in today's article I'll share my thoughts on the subject. Note: Those not familiar with Rockwell's I/O products may also...

Using The Sequencer Output Instruction in RSLogix/Studio 5000 (Video, TAS 7)

0
In this week's episode of The Automation Show, we walk through what it takes to use the Sequencer Output Instruction in RSLogix/Studio 5000: (starts at 3:00) For more information, check out the "Show Notes" located...